ST Quadrat LUX-top SDH-S Manuel De Montage page 2

Installation Instructions
®
LUX-top SDH-S
for attaching roofers' ladders and for attaching the personal protective equipment against falls
from a height
Introduction:
Before installing the anchor construction the load-bearing capacity of the roof structure must be checked.
The technical building regulations must be complied with.
Only original parts of the anchor point system may be used.
Note the installation and safety information in the user instructions.
LUX – top
Fix the
in the following installation sketch
using the three supplied woodscrews
8.0 x L mm without predrilling in the
middle of the rafter (min. 6/14 cm; min.
strength class C 24 to DIN EN 338).
IF THE REQUIRED MINIMUM ENGANGEMENT LENGTH IS NOT ENSURED DUE TO THE
ROOF CONSTRUCTION FOUND ON SITE, LONGER WOODSCREWS MUST REQUESTED
FROM THE MANUFACTURER!
ST QUADRAT Fall Protection S.A. – Ihr kompetenter Partner für Absturzsicherungen – www.lux-top-absturzsicherungen.de
roof safety hook
®
SDH-S as shown
Screw length L is specified depending on the
existing roof structure.
Minimum engagement length
in the load-bearing structural member (rafters)
= 130 mm
Seite 2 04/15