Samsung HW-K950 Manuel D'utilisation page 16

Masquer les pouces Voir aussi pour HW-K950:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

2. Align the Paper Template's Centre Line with the
centre of your TV (if you are mounting the
Soundbar below your TV), and then fix the Wall
Mount Guide to the wall using tape.
c If you are not mounting below a TV, place the
Centre Line in the centre of the installation area.
C
CENTER LINE
Centre Line
3. Push a pen tip or sharpened pencil tip through the
centre of the C-TYPE images on each end of the
Guide to mark the holes for the supporting
screws, and then remove the Wall Mount Guide.
4. Using an appropriately sized drill bit, drill a hole in
the wall at each marking.
c If the markings do not correspond to the
positions of studs, make sure you insert
appropriate anchors or mollies into the holes
before you insert the support screws. If you use
anchors or mollies, make sure the holes you drill
are large enough for the anchors or mollies you
use.
C
CENTER LINE
CENTER LINE
C
C
C TYPE : 700mm
C
C TYPE : 700mm
· 16 · English
5. Push a screw (not supplied) through each
Holder-Screw, and then screw each screw
firmly into a support screw hole.
6. Install 2 Bracket-Wall Mounts in the right
orientation on the bottom of the Soundbar, using
2 Screws (M4 x L12)
When assembling, make sure the hanger parts
of the Bracket-Wall Mounts are located
behind the rear of the Soundbar. See the
illustration below.
Rear of the Soundbar
Right end of the Soundbar

Publicité

Table des Matières
loading

Table des Matières