Dometic PERFECTVIEW M 55LX AHD Instructions De Montage Et De Service page 17

M55LX AHD, M75LX AHD
No.
11
12
13
A
NOTICE!
Cables and connections that are not properly installed will cause malfunctions or
damage to components.
Correct installation of cables and connections ensures lasting and trouble-free
operation of the retrofitted components.
Observe the following instructions when laying the connection cable:
•
If possible, use original ducts for laying the cables, or other suitable options, such as ventilation
grilles. If there are no existing ducts, you must drill a hole of ∅ 22 mm. Check beforehand that
there is sufficient space on the other side for the drill head to emerge (fig. 2, page 4).
Cover the holes with the feed through (fig. b 1, page 7) in the base of the monitor bracket.
•
•
To prevent damage to the cables, when laying them ensure that there is always sufficient
distance to vehicle components which can become hot (lights, heaters, ventilators etc.).
When laying the cables (fig. 3, page 4), make sure:
•
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection.
Connecting the monitor as a reversing video system (fig. d, page 8)
➤ Lay the connection cable for the monitor bracket on the dashboard.
➤ Insert the plug of the monitor cable (2) into the socket (4) of the connection cable (3).
Wait until you hear the plug snap in.
A
NOTICE! Beware of damage
Make sure the polarity is correct when connecting to a voltage source.
➤ Connect the red and black cables of the connection cable to a suitable voltage supply:
– Connect the red cable (5) to terminal 15 (ignition).
– Connect the black cable (6) to terminal 31 (earth).
➤ If the monitor is to be activated when reverse gear is selected, connect the green cable (7) to
the positive cable of the reversing light.
EN
Description
6-pin CAM3 socket (connection to video source 3)
with video signal detection
6-pin CAM4 socket (connection to video source 4),
with video signal detection)
Cable (blue): control input for video input CAM3
If the system is activated via this control line, none of the buttons have a
function (according to DIN EN 1501-1).
Installing the LCD monitor
17