Virax 293280 Manuel Utilisateur page 25

USE - Fig. 13 to 14
Fig. 13 –
HIGH PRESSURE CLEANER function:
Connect either one of the high pressure hoses
to the pump and to the gun.
length)
Should you wish to use the control pedal: You only need to fit it between the 2 HP
hoses observing the control pedal's HP inlet and outlet.
Fig. 14 –
PIPE UNCLOGGING / CLEANING function:
Connect either one of the high pressure hoses
the REEL'S INLET.
Connect either one of the high pressure hoses
to the HP PUMP OUTLET.
length)
FIT the hydraulic pedal between the 2 HP hoses observing the hydraulic pedal's HP
THE FACTORY ASSEMBLY IS DESIGNED TO BE USED FOR UNCLOGGING!
Your high pressure cleaner is factory equipped with a pipe or drainpipe unclogger of an
effective length of 40 m
A NOZZLE with 3 BACK-JETS
pull the hose forward while unclogging and cleaning the pipe.
The diameter of the hose and the nozzle are designed for
with pipes that are from 50 to 150 mm in diameter.
For starting up:
• Always INSERT the unclogger AT LEAST 40 cm BEFORE starting up: Otherwise you
could be splashed by water from the back-jets!
• HOLD THE HOSE during use: The joint action of flow and pressure
automatically moves the unclogger forward (even "upwards" in a drainpipe).
Other OPTIONAL back-jet nozzles are also available :

Nozzle with 3 back-jets + 1 FRONTAL jet: To break up large blockages.

ROTARY back-jet nozzles: To thorougly clean or remove coating from surfaces (ex. cement
pipes).
English
inlet and outlet.
.
is fitted to its end
(x 2 supplied : 10 m and 15 m in
(x 2 supplied : 10 m and 15 m in length)
(x 2 supplied : 10 m and 15 m in
(in 1/4") which can
maximum efficiency
Mini
Ø 50 mm
25
MAXI
Ø 150 mm
to