First Installation; Batteries Installation; Time And Date Adjustment; Starting - Watts Industries BT DP-01 Guide D'utilisation

2

First Installation

This section will guide you to set up your thermostat
for the first time.

Batteries installation

2.1
- Open the two side's covers and Insert the 2 AAA
Alkaline supplied batteries (or remove the small
protection sticker if the batteries are already
installed in the compartment)
- Close the two side's covers.
- Now your thermostat will propose you to adjust the
current time and date.

Time and Date adjustment

2.2
Each time a value blinks, you can adjust it with the
(-) and (+) keys, once the value is chosen, validate
it with the (OK) key. The thermostat will jump
automatically to the next value.
Note: you can always come back to the previous
value by pressing the escape key (
Note:
You can customise your program as you want, See
the next part "Working mode definition" chapter
"Program" for more explanation.
Curent stage
of the program
Curent time
At any time, when the backlight is extinct, press the
(OK) key to lit-up the backlight,
and then press another time the (OK) key to show
the current setting temperature
List order of the time and date adjustments:
Time and day:
Adjustment of the hours,
Adjustment of the minutes
Adjustment of the day (1 = Monday)
Date:
Adjustment of the day number
Adjustment of the month number (01 to 12)
Adjustment of the year (Century)
Adjustment of the year
Then the message "Save" and blinking green LED
appears, press (OK) to validate the adjusted time
and date.
You can always reach the time and date
adjustments, by pressing and maintaining the
edition ( ) key during 2 seconds in normal
operating modes.
).
13
3

Working mode definition

How to change the working mode?
- Open the small center cover to have access to the
Program
navigation keys (◄) or (►).
followed
- You can now press theses keys to display the
working mode line.
Move the frame cursor on the desired working
mode and press (OK) to enter in the operating
mode you have chosen.
16

Starting

2.3
The thermostat is now ready to works.
The default working mode will be automatic
with a standard built-in program "P1".
Monday to Friday
20°C
18°C
07:00 09:00
Saturday & Sunday
20°C
18°C
08:00
14

Manual mode Comfort

3.1
Manual working mode, the comfort setting
temperature will be followed all the time.
By pressing (-) or (+) keys, the comfort setting
temperature starts to blink and can be adjusted.

Manual mode, Reduced

3.2
Manual working mode, the reduced setting
temperature will be followed all the time.
By pressing (-) or (+) keys, the reduced setting
temperature starts to blink and can be adjusted.

OFF mode

3.3
Use this mode if you need to switch off your
installation.
Be Careful:
In this mode your installation can freeze.
17
17:00 23:00
23:00
15
18