Presentation; Keyboard; Display & Led; First Installation - Watts Industries BT DRF-01 Guide D'utilisation

Presentation

1.
+
-
7
1.2 Display & LED
Red Fix (when backlight is lit up): Heating
demand
Green flash: your validation is required
Red flash: Error on sensor or batteries
1
5
9
8
10
Electronic thermostat with LCD display specially
designed to control different type of heating
systems.
Due to the radio frequencies technologies it can be
easily integrated in all circumstances (renovation,
new construction...)
-
It will be your best partner to optimize your
energy consumption and increase your comfort.
- Modern design with soft touch material.
- Anti freeze function.
- Holiday or Reception function.
+
- EEPROM non volatile memory.
- 2 AAA batteries for 2 years operating life.
- 2 parameter menus, (User and Installer)
In option
- External sensor with several possibilities of
regulation. (Floor, combined...)
1. Operating mode menu (active mode is framed).
2. Parameter number if "3" is displayed.
3. Installation Parameter menu.
4. Type of sensor used and temperature
displayed.
Regulation => Internal or external ambient sensor.
Regulation => Floor sensor.
Regulation => Internal sensor with Floor limitation.
2
10
Regulation => View of the outside temperature
3
5. Heating demand indication.
6
6. Low batteries indicator.
7
7. °C or °F unit indicator
8. Setting or measured temperature if "2" is
4
displayed.
9. Key lock indicator
10. RF indicator.
Validation Key (OK)
8
11
1.1

Keyboard

Minus Key (-)
Left Navigation key (◄)
Right navigation key (►)
Escape key ( )
Edition key ( )
9

First Installation

2.
This section will guide you to set up your thermostat
for the first time.
2.1

Batteries installation

- Open the two side's covers and Insert the 2 AAA
Alkaline supplied batteries (or remove the small
protection sticker if the batteries are already
installed in the compartment)
- Close the two side's covers.
- Now your thermostat will propose you to adjust the
current time and date.
2.2

RF installation

- First of all to configure your thermostat with the
receiver, you must put your receiver in « RF init ».
mode. (please refer to the receiver leaflet for this,
only the RF receiver of the same range are
compatibles)
12
Plus Key (+)
Status LED