Operation - Husqvarna LC 151 Manuel D'utilisation

2. Move the knobs up in the direction of the handle until
they stop and you hear a click.
3. Tighten the knobs fully.
To assemble the grass catcher (LC
151, LC 151S)
1. Attach the grass catcher frame to the grass bag with
the rigid part of the bag on the bottom. Keep the
handle of the frame out of the top of the bag.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
• Extended product information.
• Information about, and help with, product parts and
servicing.
To start to use Husqvarna Connect
1. Download the Husqvarna Connect app on your
mobile device.
2. Register in the Husqvarna Connect app.
3. Do the instruction steps in the Husqvarna Connect
app to connect and register the product.
8

Operation

Before you operate the
2. Attach the grass bag to the frame with the clips.
Before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Examine the cutting equipment to make sure that it
is correctly attached and adjusted. See
the cutting equipment on page 13 .
3. Fill the fuel tank. See
4. Fill the oil tank and do a check of the oil level. See
To do a check of the oil level on page 14 .
To fill fuel
If available, use low-emission/alkylate gasoline. If low-
emission/alkylate gasoline is not available, use good
quality unleaded gasoline or leaded gasoline with octane
number not less than 90.
CAUTION:
octane number less than 90 RON (87 AKI).
This can cause damage to the product.
To examine
To fill fuel on page 8 .
Do not use gasoline with an
1566 - 008 - 24.11.2021