Status Commands - Promax GR-205 Manuel D'instructions

USER'S MANUAL. GR-205

6.3.4 Status Commands

*LRN?
LRN
<character data> Install data from a previous *LRN? command. Note that the
EER?
QER?
*CLS
*ESE <nrf>
*ESE?
*ESR?
*IST?
*OPC
*OPC?
*PRE <nrf>
*PRE?
*SER <nrf>
09/2004
Returns the complete set up of the instrument as a
hexadecimal character data block approximately 84 bytes
long. The syntax of the response is LRN <data><rmt>.
To re–install the set–up return the block exactly as
received, including the LRN header at the beginning of the
block, see below. The settings in the instrument are not
affected by execution of the *LRN? command.
LRN header is provided by the *LRN? response block.
Query and clear Execution Error Register. The response
format is nr1<rmt>.
Query and clear Query Error Register. The response format
is nr1<rmt>.
Clear Status. Clears the Standard Event Status Register,
Query Error Register and Execution Error Register. This
indirectly clears the Status Byte Register.
Set the Standard Event Status Enable Register to the value
of <nrf>.
Returns the value in the Standard Event Status Enable
Register in <nr1> numeric format. The syntax of the
response is <nr1><rmt>.
Returns the value in the Standard Event Status Register in
<nr1> numeric format. The register is then cleared. The
syntax of the response is <nr1><rmt>.
Returns ist local message as defined by IEEE Std. 488.2.
The syntax of the response is 0<rmt>, if the local message
is false or 1<rmt>, if the local message is true.
Sets the Operation Complete bit (bit 0) in the Standard
Event Status Register.
This will happen immediately the command is executed
because of the sequential nature of all operations.
Query Operation Complete status. The syntax of the
response is 1<rmt>.
The response will be available immediately the command is
executed because of the sequential nature of all
operations.
Set the Parallel Poll Enable Register to the value <nrf>.
Returns the value in the Parallel Poll Enable Register in
<nr1> numeric format.
The syntax of the response is <nr1><rmt>
Set the Service Request Enable Register to <nrf>.
Page 33