Command List - Promax GR-205 Manuel D'instructions

Commands are sent as <PROGRAM MESSAGES> by the controller, each
message consisting of zero or more <PROGRAM MESSAGE UNIT> elements
separated by <PROGRAM MESSAGE UNIT SEPARATOR> elements.
A <PROGRAM MESSAGE UNIT> is any of the commands in the remote
commands list.
A <PROGRAM MESSAGE UNIT SEPARATOR> is the semi-colon character ';'
(3BH).
<PROGRAM MESSAGES> are separated by <PROGRAM MESSAGE
TERMINATOR> elements which may be any of the following:
NL
NL^END
^END
Responses from the instrument to the controller are sent as <RESPONSE
MESSAGES>. A <RESPONSE MESSAGE> consists of one <RESPONSE MESSAGE
UNIT> followed by a <RESPONSE MESSAGE TERMINATOR>.
A <RESPONSE MESSAGE TERMINATOR> is the new line character with the
END message NL^END.
Each query produces a specific <RESPONSE MESSAGE> which is listed along
with the command in the remote commands list.
<WHITE SPACE> is ignored except in command identifiers. e.g. '*C LS' is not
equivalent to '*CLS'. <WHITE SPACE> is defined as character codes 00H to 20H
inclusive with the exception of the NL character (0AH).
The high bit of all characters is ignored.
The commands are case insensitive.

6.3 Command List

This section lists all commands and queries implemented in this instrument. The
commands are listed in alphabetical order within the function groups.
Note that there are no dependent parameters, coupled parameters, overlapping
commands, expression program data elements or compound command program
headers; each command is completely executed before the next command is started.
All commands are sequential and the operation complete message is generated
immediately after execution in all cases.
Page 30
The new line character (0AH)
The new line character with the END message
The END message with the last character of the message
USER'S MANUAL. GR-205
09/2004