Pentair Water Pool and Spa LIL SHARK Mode D'emploi page 27

More About the Cleaner and Accessories:
Swivel Assembly:
• Insert assembly into cleaner body and
turn 1/4 turn clockwise.
• If you attach a unidapt handle to the
swivel for manual vacuuming, be sure
it is a special, floating unidapt handle
(order No. GW9019; purchase locally).
Use of a different unidapt handle will
1105 0694
hinder the cleaner's performance.
Hose:
• The unit includes a 20' hose, an 8' hose,
and a 4' hose which will provide excel-
lent coverage in pools up to 27'.
4'
• For pools larger than 27', add an 8'
extension hose. (Order No. GW9511;
purchase locally).
20'
• For pools smaller than 24', try the three
hoses together. If 32' is too much hose,
remove the 8' section and use only 24'
of hose.
8'
• The hose was designed specifically for
the cleaner. Use of a different type of
hose will reduce the cleaner's perfor-
mance.
1104 0694
Reducer Cone:
• Adapts hose to some skimmers.
• Keeps hose in place in skimmer when
pump stops.
Brush Adjustment
1106 0694
NOTICE: Bristle wear, pool
bottom, temperature, etc., will
all affect cleaner operation.
Use these general guidelines
to adjust your cleaner for best
performance.
Cleaner is factory set at No. 1.
Tight Circles
Clockwise
Tight Circles
Clockwise
Automatic
Vacuum Regulator:
trap or tear hair or body parts. Install
vacuum regulator on all high-vacuum
systems.
• Every system requires a vacuum
regulator for safe operation.
1080 0694
• Regulator provides vacuum relief in
case cleaner suction is blocked.
• Black rubber diaphragm must
always be submerged. If it sucks air,
the pump will lose prime, which
could damage the pump.
Flow Director:
• Install the flow director only if your
existing inlet fitting in pool does no
give the desired results.
• For best cleaning action, angle the
1061 0694
flow down 45° in a fan out from pool
side (see illustration below).
Moderate Circles
Clockwise
Moderate Circles
Clockwise
3
Hazardous suction. Can
926 0594
Straight Ahead
Travel
Straight Ahead
Travel