JB Systems SUPER QUADRA BEAM Mode D'emploi page 8

ENGLISH
 SL I: the device will run 100% sinchronously with the master device.
 SL 2: the device will run sinchronously with the master device, but from time to time the effects will be
inverted to create more diversity in the show.
 Once the right mode is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to store the setting and to return to running mode.
Sound Mode
Used to activate or to deactivate the sound mode to trigger the shows.
 Press the MENU button until
 Press the ENTER button to select.
 Use DOWN and UP button to select one of the available modes:

(sound mode ON)  the shows are triggered by the internal microphone.

(sound mode OFF)  the shows runs at slow speed.
 Once the right mode is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to store the setting and to return to running mode.
Blackout Mode
Blackout mode: when no DMX-signal is detected, the unit goes in blackout.
No blackout mode: when no DMX-signal is detected, the unit automatically switches to master mode.
ALWAYS set to "No Blackout" when the unit is used in standalone or master (master/slave) mode!!!
 Press the MENU button until
 Press the ENTER button.
 Use DOWN and UP button to select
 Once the mode is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to store the setting and to return to running mode.
Led Display
Display on: display is always on.
Display off: display is off when not used.
 Press the MENU button until the display shows
 Press the ENTER button.
 Use DOWN and UP buttons to select
 Once the mode is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to store the setting and to return to running mode.
Display Inversion
Display inversion: display is readable when the unit is mounted upside down.
 Press the MENU button until the display shows
 Press the ENTER button, the display starts blinking.
 Use DOWN and UP buttons to select the display inversion or the normal display.
 Once the mode is selected, press the ENTER button to confirm.
 Press the MENU button for about 2 seconds to store the setting and to return to running mode.
Self-Test
Used to activate the internal "self-test" program that runs continuously.
Press the MENU button until the display shows
 Press the ENTER button to start the internal self-test program.
 The unit will run continuously in sequence each individual LED
 This self-test allow the user to check if all the LEDs are working perfectly.
If you want to go back to normal running mode: press the MENU button for about 2 seconds.
JB SYSTEMS
®
is shown on the display.
is shown on the display.
(blackout) or
.
(display always on) or
.
6/47
OPERATION MANUAL
(no blackout).
(display off when not used).
SUPER QUADRA BEAM