JB Systems SUPER QUADRA BEAM Mode D'emploi page 10

ENGLISH
1 CHANNEL MODE
SHOW
VALUE FUNCTION
248-255 RANDOM
218-247 SHOW 8
188-217 SHOW 7
158-187 SHOW 6
128-157 SHOW 5
098-127 SHOW 4
068-097 SHOW 3
038-067 SHOW 2
008-037 SHOW 1
000-007 OFF
3 CHANNEL MODE
1 - SHOW
VALUE FUNCTION
248-255 RANDOM
218-247 SHOW 8
188-217 SHOW 7
158-187 SHOW 6
128-157 SHOW 5
098-127 SHOW 4
068-097 SHOW 3
038-067 SHOW 2
008-037 SHOW 1
000-007 OFF
 Important: Never look directly into the light source! Don't use the effect in the presence of persons
suffering from epilepsy.
MAINTENANCE
 Make sure the area below the installation place is free from unwanted persons during servicing.
 Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
 All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
 Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
 When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
 The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
 In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
 The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
JB SYSTEMS
®
2 - SPEED
VALUE FUNCTION
AUDIO
248-255
TRIGGER
247 FAST
008-247 MANUAL
SPEED
CHANGE
008 VERY SLOW
000-007 HOLD (stop)
8/47
OPERATION MANUAL
3 - STROBE
VALUE FUNCTION
255 FAST STROBE
068 SLOW STROBE
SOUND
038-067
STROBE
RANDOM
008-037
STROBE
000-007 NO STROBE
SUPER QUADRA BEAM