Taurus Alpatec AC 201 Mode D'emploi page 11

TIMER FUNCTION:
SETTING TIMED ON FUNCTION:
- With the air conditioner off, press button "F" and
select the desired ON time by using the Tempe-
rature and Time setting buttons.
- The ON time can be set up to 24 hours
- The set time or time remaining will appear on
the display (E).
SETTING TIMED OFF FUNCTION:
- With the air conditioner on, press button "F"
and select the desired OFF time by using the
Temperature and Time setting buttons.
- The OFF time can be set up to 24 hours
- The set time or time remaining will appear on
the display (E).
COOLING MODE:
- Press mode to select cooling mode, the cool
mode indicator will be displayed.
- Press + or - to set the temperature within a
range of 16~31ºC (61~88ºF)
- Press + or - once to increase/decrease the
temperature gradually.
- Press (E) to select high or low fan speed.
FAN MODE:
- Press mode (D) to select fan mode and the fan
indicator will be displayed
- Press (E) power to increase or decrease the
speed.
DEHUMIDIFYING MODE:
- Press mode (D) to select dehumidify mode and
the dehumidifier indicator will be displayed
COMPRESSOR PROTECTION:
- Three minutes later after power on / restart,
compressor starts to run.
WATER TANK FULL PROTECTION:
- When the water level in the bottom water plate
is above the warning level, the unit will alert
automatically a.
- Please discharge water in the machine accor-
ding to chapter "water drainage".
WATER DRAINAGE:
- When the inner water tank is full, its indicator will
flash on the screen.
- The appliance enters into standby mode.
- Pull out the plug to drain out water, power off the
machine and restart it , the machine will runs
normally .
-This model have self evaporative function, under
cooling mode, please do not use continue drai-
nage to get better cooling effect.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Stop the appliance by pressing the ON/Off
button (A)
- Unplug the appliance from the mains.
Disconnect the appliance from the mains and let
it cool before undertaking any cleaning task.
Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO
NOT IMMERSE IN WATER OR ANY OTHER
LIQUID.
CLEANING
- Limpiar el aparato con un paño húmedo im-
pregnado con unas gotas de detergente. Do not
use solvents, or products with an acid or base
pH such as bleach, or abrasive products, for
cleaning the appliance.
- Never submerge the connector in water or any
other liquid or place it under running water. If the
appliance is not in good condition of cleanliness,
its surface may degrade and inexorably affect
the duration of the appliance's useful life and
could become unsafe to use.
AIR FILTER CLEANING:
- Clean the air filters every 2 weeks. If the air filter
is blocked with dust, the efficiency will reduce.
-Wash the air filters by immersing it gently into
warm water with a neutral detergent, rinse it and
dry it thoroughly in a shaded place.
-Install air filters carefully after cleaning the filters.
AFTER SEASON MAINTENANCE:
- Turn off the unit and pull out the plug.
- Separate the air-vent pipe and store it away
safely.
- Store the appliance in a cool, dry place.
- Take the batteries out of the remote control and
store them away safely.
FAULTS AND REPAIR
- Take the appliance to an authorised technical
support service if problems arise. Do not try to
dismantle or repair it, as this may be dangerous.
- If any anomaly is detected, check the following table: