Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Adding RISCO PRO Camera
1. Enter the Username and Password. The Username is "admin". The default
Password is "_AdmiN_ MAC address" (for example,
_AdmiN_AABBCCDDEEFF).
NOTE: For enhanced security, it is recommended to change the default
password.
2. Recording Mode: If "Motion Detected" is selected, the NVR will record only
if motion is detected by the camera. If "Continuous" is selected, the camera
will record continuously.
3. Click Save & Continue. Repeat the procedure for the other cameras until all
cameras you have selected for the NVR are setup. The following screen
provides a summary of the cameras that have been connected successfully
or that failed to be connected to the NVR.
NOTE: RISCO Pro cameras can be viewed via the NVR only, and cannot be
installed as standalone cameras.
Figure 13 Adding RISCO Pro Camera
14
Publicité
Table des Matières
