Electrical Hook Up - Waring Commercial WWB10G Serie Manuel D'utilisation

Distributeur d'eau chaude de 10 gallons (37,85 l)

Masquer les pouces

Table des Matières

Les langues disponibles

sturdy surface where it will not be knocked into. Be sure to leave

at least 6" (15 cm) on right side of hot water dispenser for proper

venting. Position hot water dispenser so that the faucet can be

easily accessed.

5. Level the hot water dispenser by adjusting the legs to your

desired height.

6. Ensure the lid is on top of unit.

7. Slide the overflow tray into slots underneath.

WATER HOOK UP FOR AUTO-FILL MODE

NOTE: The hot water dispenser must be installed in compliance

with applicable federal, state and/or local plumbing codes having

jurisdiction. This product requires an approved backflow prevention

water device, such as a double check valve, to be installed between

the machine and the water supply. Incoming pressure should be

greater than 30 psi and not more than 70 psi.

NOTE: Connecting the hot water dispenser to a warm water supply

will speed up heating and recovery times.

1. Hot water dispenser is equipped with a ¾" GHT (garden hose

thread) flare water inlet fitting, which is located on the back of

the unit.

2. Provide shutoff valve and union in supply line near hot water

dispenser.

3. Minimum inlet pressure at hot water dispenser should be 30 psi

and maximum inlet pressure recommended at 70 psi.

4. Turn on the water supply line and check for leaks.

NOTE: A filtering system is recommended to remove odors and

inhibit lime and scale buildup in the unit.

NOTE: In areas with extremely hard water, a water softener must

be installed in order to prevent mineral deposits that may cause

malfunctioning of the equipment.