Setting The Clock; Water Source; Night Mode - Waring Commercial WWB10G Serie Manuel D'utilisation

SETTING THE CLOCK

1. To set the clock, press and hold the
2 seconds.
2. Use the
3. O nce the desired time is displayed, wait 10 seconds, and the
time will be set. Display will show set time for 3 seconds.

WATER SOURCE

Autofill Mode
1. When in autofill mode, auto fill icon flashes while unit is filling
with water.
2. The heater will start when water level reaches low-level sensor.
Note: if water does not reach the low-level sensor within 5
minutes, error code 6 flashes on screen. See troubleshooting
section for details.
3. When water reaches temperature, unit will display READY along
with the set temperature.
Manual Mode
You must change the setting on the hot water dispenser to manual
mode if you wish to fill water manually. This will prevent the unit from
thinking water will automatically fill.
Press Autofill/manual mode to toggle to manual mode.
To fill manually:
1. Remove the lid and fill with water.
2. While filling, the manual mode icon will flash until the minimum
water level is reached. Once the max fill (10 gal) is reached, the
icon will go off.
3. When water reaches temperature, unit will display READY along
with the set temperature.

NIGHT MODE

In Night Mode, unit will maintain water temperature at 158°F/70°C
during non-business hours to save energy and enable a quicker
heat up time, so that hot water is ready when you need it. When
setting the time for night mode, you will be setting the time the unit
will be re-energized and will start heating the water to your pre-set
temperature. (i.e. 5:00 am – unit will turn back on and starts heating
to 205°F).
arrows to scroll.
10
button for