Hilti SFC 18-­A Mode D'emploi page 9

CAUTION
Risk of injury. If the battery is not fitted correctly it may drop out and fall.
▶ Check that the battery is securely seated in the tool so that it cannot drop out and fall, thereby
presenting a hazard to other persons.
▶ Push the battery into the tool from the rear until it engages with an audible click.
5.2 Removing the battery
▶ Remove the battery.
5.3 Fitting the accessory tool
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool into the keyless chuck and then turn the chuck firmly by hand until tight and
several clicks are heard.
5. Check that the accessory tool is held securely.
5.4 Removing the accessory tool
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Open the keyless chuck.
3. Pull the accessory tool out of the keyless chuck.
5.5 Switching on
▶ Press the control switch.
Note
Speed can be controlled steplessly right up to maximum by varying how far the control switch is
pressed in.
5.6 Switching off
▶ Release the control switch.
5.7 Drilling
1. Set the torque and operating mode selector ring to the
2. Set the forward/reverse switch to the "forward" position.
5.8 Screwdriving
1. Set the torque and operating mode selector ring to the required torque.
2. Set the forward/reverse switch to the desired direction of rotation.
5.9 Setting forward or reverse rotation
Note
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the middle position (safety lock).
▶ Set the forward/reverse switch to the desired direction of rotation.
5.10 Selecting the gear
▶ Select the gear.
Printed: 27.07.2016 | Doc-Nr: PUB / 5293248 / 000 / 00
3
5
6
symbol.
5