TERMOTECNICA PERICOLI PERIcooler 31 Mode D'emploi page 31

6.4 INSTALLATION OF THE COOLER
The holder onto which the cooler is attached has to be sized
by adopting a suitable safety factor (chosen according to the
regulations in force in the field).
For sizing, one must however consider the weight of the
PERIcooler when fully charged, the machine vibration and
the potential additional weight of the staff who will perform its
maintenance.
Measurement for these features is necessary for the installer
and only the latter will be able to assess the feasibility.
It is forbidden to install the machine on surfaces with strength
and stiffness features that are not suitable for this purpose.
If the machine is mounted on suspended shelves or if there is the
least possibility of fall and / or overturning, it shall be necessary to
firmly strengthen the machine holder.
In order to secure the machine on holder it is necessary to use
the 16 holes present on the corners of the base. See the image
below.
ATTENTION
Do not install the WSK kit on machines intended to be used on
shelves and/or in places where there is the slightest possibility of
falling and/or overturning.
To comply with the basic safety standards, in case of installation
on the floor it is mandatory to use a safety net for the fan (the
SK kit).
We recommend that you refer to trained technicians to connect
electrical and hydraulic, as well as for the design of shelves, bases
or floors suitable to support the PERIcooler, taking into account its
weight and construction and operation features.
TERMOTECNICA PERICOLI S.r.l.
circumstances for the damage caused to objects and / or people
due to installation of one or more machines on inadequate surfaces
PERIcooler_U171200
is not liable under any
ATTENTION
The cooler must be installed on a perfectly plane surface. Do not
place the machine on inclined and / or uneven surfaces.
6.5 TYPOLOGY OF APPLICATION
The PERIcooler may be used in a fixed external site or an
internal mobile one, depending on the requirement.
ATTENTION
If the PERIcooler's is installed outside the premises to be
conditioned properly sized windows or openings that ensure
the correct air flow without creating overpressure zones have
to be provided.
The two main typologies of application are using the machine with
a PE tube or with a direct jet, although the high versatility allows the
installation of a wheel kit (WSK), which makes the cooler mobile (for
further information, contact the commercial department).
Refer to the application examples on the last pages of the manual.
31