TERMOTECNICA PERICOLI PERIcooler 31 Mode D'emploi page 26

6.2 INSTALLATION OF UNASSEMBLED PARTS
6.2.1 Installation of the fan group
If the cooler is supplied with the fan group that is not installed,
fastening to the body of the machine body must be provided.
NOTE
The operations indicated below should occur only before
connecting the cooler.
ATTENTION
For installation, follow the pictures below, paying attention to the
reference points highlighted.
Kit SK (optional)
A
In case of purchasing the set SK (OPTIONAL), the net must be
attached to the cooler ring by means of 4 screws and 4 rings, as
shown in image A.
Position the fan group at an angle, according to the special
column (as indicated by the warning triangle) and insert it from
below (as shown in image B), then bring it upright and secure it
with 4 screws as shown in image C.
B
x1
26
C
TE 6x16
x4
6x18
x4
Locking
Torque
10 Nm
Complete the operation by positioning the two cable channels in
the special left column, then pass the fan cable through the most
external hole (as shown in image D).
NOTE
At the end of the installation ensure that the engine cable has
been completely pulled through and that it is integral and free
of cuts and / or distortions
Locking
Torque
TE 8x20 20 Nm
x4
PERIcooler_U171200