T-Fal ActiFry Genius Mode D'emploi page 14

A FEW TIPS IN CASE OF PROBLEMS...
Problems
The appliance does
not work.
The paddle does
not stay in place
The food has not
been cooked
uniformly.
The chips are not
crunchy enough.
The chips break during
cooking.
14
Causes
The appliance is not plugged
in properly.
You have not yet pressed
button .
You have pressed button
but the appliance does not
operate.
The appliance is not heating.
The paddle does not turn.
The paddle is not locked.
You have not used the paddle.
The food / chips have not
been cut uniformly.
You are not using a potato
variety that is recommended
for chips.
The potatoes are
insuffciently washed and/or
not completely dried.
The chips are too thick.
There is not enough oil.
The filter is clogged.
The quantity is too large.
Solutions
Make sure the appliance is properly
plugged in to a main power socket.
Press button .
Close the lid.
Call the customer Helpline below.
1-800-418-3325
The paddle does not turn at the
beginning of cooking in cooking
modes 2, 3, 4, 5, 7, 8 and 9. Restart
using the manual mode to check
the paddle turns. If it does not
turn, check that it is inserted in the
correct position. Otherwise, call the
customer Helpline below:
1-800-418-3325
Reposition the paddle until you
hear it «CLICK» - fig.12.
Put it in position.
Cut the food / chips all to the
same size.
Choose a potato variety that is
recommended for chips such as
Maris Piper or King Edward potatoes.
Wash potatoes for a long time to
remove the starch, drain and dry
very thoroughly before cooking.
They must be completely dry.
Cut them more thinly. The maximum
chip dimensions are 13 mm x 13 mm.
Increase the amount of oil (see
cooking table p. 11 to p. 13).
Clean the filter.
Reduce the amount of potatoes
and adjust the cooking time.