Troubleshooting - MasterCraft 058-1289-2 Manuel D'installation

16
model no. 058-1289-2 | contact us 1-800-689-9928

TROUBLESHOOTING

Problem
Low pressure, or
not enough air,
or
compressor does
not stop.
Excessive starting
and stopping while
not in use.
Circuit breaker
trips.
Overheating.
headline bars headline bars
Possible Causes
Tank drain valve is open.
Fittings leak.
continuation tabs continuation tabs
Prolonged excessive use of air.
Compressor not large enough.
notes notes
Restricted check valve.
Hole in air hose.
Tank leaks.
Valve leaks.
warnings warnings
Fittings leak.
Low voltage.
Excessive wire length.
Restricted air passages.
Back pressure in pump head.
Poor ventilation.
Dirty cooling surfaces.
Leaking valve.
Solution
Close drain valve.
Check fittings with soapy water. Tighten
or reseal leaking fittings. DO NOT
OVERTIGHTEN.
Decrease amount of air used.
Check air requirement of accessory. If it
is higher than CFM and pressure
supplied by compressor, you need a
larger compressor. Most accessories
are rated at 25% of actual CFM while
running continuously.
Remove and clean or replace.
Check and replace if necessary.
Immediately replace tank.
DO NOT attempt to repair.
Replace worn parts and reassemble.
Check fittings with soapy water. Tighten
or reseal leaking fittings. DO NOT
OVERTIGHTEN.
Replace worn parts and reassemble
with new seals.
Furnish adequate power. If using
extension cord, try without.
Consult electrician.
Contact authorized service centre.
Replace check valve, pressure switch,
bleeder valve.
Relocate compressor to an area with
cool, dry and well-circulated air.
Clean all cooling surfaces of pump and
motor thoroughly.
Replace worn parts and reassemble
with new seals.