Adding A New Remote Control Or Remote Keypad To The Siren - Honeywell FRIEDLAND FGGA04 Série Manuel D'installation Et D'utilisation

5.3

Adding a new remote control or remote keypad to the siren

If you set up the siren without separate control panel (single zone) for the first time, you must link the siren to a remote keypad
or a remote control before adding other devices. The ID code of the remote control or the remote keypad must be learned by
the siren. The siren can learn up to 6 remote controls or remote keypads.
During setup, the siren will power up in service mode, ready to learn a new remote control or remote keypad. If the siren is in
operating mode, refer to the section "Service mode / Operating mode" to switch to service mode.
1
The siren emits one short beep. The indicators in the front lens and the learn indicator flash slowly.
2
Press the
The siren emits two short beeps. The indicators in the front lens and the learn indicator flash quickly.
Note: If the remote control or the remote keypad has already been linked or if the maximum number of 6 remote controls
or remote keypads are linked, the siren will emit one short beep and exit learn mode. The indicators in the front
3
Press the
The siren emits three short beeps. The indicators in the front lens and the learn indicator come on for 3 seconds and
Note: If the confirmation signal is not received within 15 seconds, the siren will emit one short beep and exit learn mode.
3.
4.
Caution:

5.
Remote control
Press and hold the learn button on the siren for 5 seconds to enter learn mode.
button.
lens and the learn indicator will go off.
button within 15 seconds.
go off. The siren returns to service mode.
The indicators in the front lens and the learn indicator will go off.
1.
2.
Press the tamper switch. The indicators in the front lens flash
several times and then continue to flash alternately every 5 seconds
to indicate that the siren is operational.
Remove the protective film from the solar panel.
Make sure that the solar panel receives sufficient light to maintain
the battery charge.
a) If switch 5 is set to ON (siren), the siren will operate without
control panel (single zone).
b) If switch 5 is set to OFF (control panel), the siren will operate
with control panel. For linking the siren to the control panel, refer
to the Installation and Operation Manual for the alarm system and
to the Quick Installation Guide for the siren.
Program the ID code:
Enter the 4-digit ID code. Press the
Confirm the ID code:
Enter the 4-digit ID code and press the
Install the battery cover.
Install the screws.
6
Remote keypad
button.
button
within 15 seconds.