Disposal - Sanitas SBF 72 Mode D'emploi

Display
No Bluetooth con-
®
nection ( symbol is
missing).
Measurements are not
transferred to the app
-symbol does not
appear)
-symbol appears
briefly after measure-
ment.
Lo

10. Disposal

Empty, completely flat batteries must be disposed of through specially designated collection boxes, recy-
cling points or electronics retailers. You are legally required to dispose of the batteries.
The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.
For environmental reasons, do not dispose of the device in the household waste at the end of its service
life. Dispose of the device at a suitable local collection or recycling point in your country.
Dispose of the device in accordance with EC Directive – WEEE (Waste Electrical and Electronic
Equipment). If you have any questions, please contact the local authorities responsible for waste
disposal.
Dispose of packaging in an environmentally friendly manner.
Cause
Device outside the range.
No connection to the app.
No new user measurement and
no Bluetooth connection with
®
the app.
User memory space is full.
The oldest measured values
are overwritten with newer
measured values.
The batteries in the scale are
empty.
Solution
The minimum range in the open is approx.
10 m. Walls and ceilings reduce the range.
Other radio waves may interfere with the
transmission. Therefore, do not position the
scale near devices such as WiFi routers,
microwaves, induction hobs, etc.
Close the app completely (including in the
background). Switch Bluetooth
back on again. When doing so, please note
that the scale must not be connected from
the Bluetooth
tem. If need be, remove it from the devices
list in the Bluetooth
the "Sanitas HealthCoach" app. Switch the
smartphone off and back on again. Remove
the batteries in the scale for a short period
and reinsert them.
The user memory space which appears
on the scale display must be assigned to
the scale in your app settings. Only these
measurements can be transferred. There-
fore, check your user spaces and your app
settings for this user and carry out a user
measurement again. In doing so, „
example has to be displayed on the scale
and in the app this user „1" has to be assi-
gned in the device settings of the scale.
Open the app and switch the scale on. If
you do not want to use the app, ignore this
message.
Replace the batteries in the scale.
20
PAP
25
off and
®
settings of the operating sys-
®
settings, and then use
®
" for