Analysis Of Measured Values - Beurer BF 1000 Mode D'emploi

Masquer les pouces Voir aussi pour BF 1000:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 37
8.3 User measurement, total body analysis
– Press the [ ] button on the control unit. 0.0 kg appears in the display.
If guest mode has been activated in the scale settings, step onto
the scale when it is switched off.
– Stand on the scale barefoot holding the control unit in your hands.
Hold the control unit with the underside of your thumbs on the front
electrodes and with your fingers pressed firmly against the back elec-
trodes.
– Stand still with your weight distributed equally on both feet. Make
sure there is no skin contact between your two feet, legs, calves and
thighs.
– If the scale recognises you automatically, the impedance for the anal-
ysis will be measured after the weight measurement. This is indicated
by the symbol showing current passing through the body.
– As soon as the total body analysis is complete, the overview will be
shown. The measurement is automatically stored.
Note: The measurement will not be saved if the following applies:
– The user is not automatically detected. This happens if your measured weight differs from the
previous measurement by +/- 3 kg or if another user has similar values (+/- 3 kg) to yours. In this
case, press the [
– The user is standing on the scale with shoes on.
– The user is not holding the handheld unit with their hands.

9. Analysis of measured values

The results will be analysed automatically after taking the measurement or after selecting the user man-
ually on the control unit. Select your user using the [
seconds.
General overview
The general overview appears at a glance in the display either before or
after a total body analysis for your user.
Segment analysis for body fat and muscle percentage
a) Body fat in left and right arm
– Press the menu button [
for body fat in the left and right arm appears in the display.
] button to select the user manually and to carry out the measurement again.
] until
is selected. The segment analysis
] button. Confirm using the [SET] button or wait 3
28
23-05-2018
18:33
88.8
M
kcal
Segment analysis
Initials
23-05-2018
18:33
88.8
M
kcal
BF
ok
23-05-2018
18:33
BF
Left arm
Right arm

Publicité

Table des Matières
loading

Table des Matières