Transferring Measurements Via App; Additional Information; Changing The Batteries - Beurer BF 1000 Mode D'emploi

The interpretation of the results is based on changes in total body weight, percentage of body fat, body
water and muscle content, as well as on the length of time over which these changes occur. Rapid
changes within the scope of a few days are to be considered separately from medium-term changes (in
the scope of weeks) and long-term changes (months).
It can be said as a basic rule that short-term changes in weight are almost entirely changes in water con-
tent, whereas medium-term and long-term changes may also relate to the fat percentage and the muscle
percentage.
• If your weight drops in the short term but your body fat percentage increases or stays the same, you
have only lost water, for example following a training session, visit to the sauna or a diet aimed only at
fast weight loss.
• On the other hand, if your weight increases in the medium term and your body fat percentage drops or
stays the same, you may have built up valuable muscle mass.
• If your weight and body fat percentage both fall at the same time, then your diet is working – you are losing
fat mass.
• Ideally, you should support your diet with physical activity, fitness or strength training. This enables you
to increase your muscle percentage in the medium term.
• Body fat, body water and muscle percentages should not be totalled (muscle tissue also contains com-
ponents made of body water).

11. Transferring measurements via app

If the app is not open, the newly assigned measurements are saved on the scale. A maximum of 30 meas-
urements per user can be saved on the scale. The saved measurements are transferred automatically to
the app when you open the app within the Bluetooth
when the scale is switched off if Bluetooth

12. Additional information

Deleting scale data
a) Delete user with all settings and saved values
• After switching on, select your user by pressing the [
times and confirm with [SET].
• When 0.0 appears in the display, hold down the [SET] button for 12 seconds to delete the user.
• Use the [ , ] buttons to select "YES" and confirm the prompt using the [SET] button. If you do not
want to delete the user, confirm "NO" using the [SET] button.
All saved values and settings for this user will be deleted.
b) Delete individual saved value for a user
• Select a measured value in the user memory
delete the stored value displayed.
• You can also do this immediately after the measurement is taken.
• Use the [ , ] buttons to select "YES" and confirm the prompt using the [SET] button. If you do not
want to delete the value, confirm "NO" using the [SET] button.
c) Delete all stored values for a user
• Open the user memory
all values.
• Use the [ , ] buttons to select "YES" and confirm the prompt using the [SET] button. If you do not
want to delete, confirm "NO" using the [SET] button.

Changing the batteries

The control unit has a low battery indicator. "LOW BATTERY" appears in the display if the batteries in the scale
are too weak. In this case, the batteries should be replaced. Connect the scale to the app again. The system
time is updated.
is enabled in the device settings.
®
and briefly press the [SET] button on the control unit to
and press the [SET] button on the control unit for around 5 seconds to delete
range. It is possible to automatically transfer data
®
] button. If necessary, press the button several
33