Cooktop Use - Whirlpool YWFE50M4HS Instructions D'utilisation

WARNING
Fire Hazard
Turn off all controls when done cooking.
Failure to do so can result in death or fire.
REMEMBER: When range is in use or (on some models)
during the Self-Cleaning cycle, the entire cooktop area may
become hot.
Ceramic Glass
The surface cooking area will glow red when an element is ON.
Some parts of the surface cooking area may not glow red when an
element is ON. This is normal operation. It will also randomly cycle
off and back on again, even while on High, to keep the cooktop
from extreme temperatures.
It is normal for the surface of light-colored ceramic glass to appear
to change color when surface cooking areas are hot. As the glass
cools, it will return to its original color.
Clean the cooktop after each use to help avoid scratches, pitting,
abrasions, and to condition the glass surface. Ceramic glass
cooktop cleaner and a cooktop scraper are also recommended
for stubborn soils. Do not use abrasive cleaners, cleaning pads,
or harsh chemicals for cleaning. The Cooktop Care Kit Part
Number 31605 contains all of the items needed to clean and
condition your ceramic glass cooktop. Refer to the "Range Care"
section for additional information.
IMPORTANT: To avoid permanent damage to the cooktop surface
and to make soils easier to remove, clean the cooktop after each
use to remove all soils.
Avoid storing jars or cans above the cooktop. Dropping
■
a heavy or hard object onto the cooktop could crack
the cooktop.
To avoid damage to the cooktop, do not leave a hot lid on
■
the cooktop. As the cooktop cools, air can become trapped
between the lid and the cooktop and the ceramic glass could
break when the lid is removed.
For foods containing sugar in any form, clean up all spills and
■
soils as soon as possible. Allow the cooktop to cool down
slightly. Then, while wearing oven mitts, remove the spills
using a scraper while the surface is still warm. If sugary spills
are allowed to cool down, they can adhere to the cooktop and
can cause pitting and permanent marks.

COOKTOP USE

To avoid scratches, do not slide cookware or bakeware across
■
the cooktop. Aluminum or copper bottoms and rough finishes
on cookware or bakeware could leave scratches or marks on
the cooktop.
Do not cook popcorn in prepackaged aluminum containers on
■
the cooktop. They could leave aluminum marks that cannot be
removed completely.
To avoid damage to the cooktop, do not allow objects that
■
could melt, such as plastic or aluminum foil, to touch any part
of the entire cooktop.
To avoid damage to the cooktop, do not use the cooktop as a
■
cutting board.
Use cookware about the same size as the surface cooking
■
area. Cookware should not extend more than
outside the area.
Use flat-bottomed cookware for best heat conduction and
■
energy efficiency. Cookware with rounded, warped, ribbed,
or dented bottoms could cause uneven heating and poor
cooking results.
Determine flatness by placing the straight edge of a ruler
■
across the bottom of the cookware. While you rotate the
ruler, no space or light should be visible between it and
the cookware.
Cookware designed with slightly indented bottoms or small
■
expansion channels can be used.
Make sure the bottoms of pots and pans are clean and dry
■
before using them. Residue and water can leave deposits
when heated.
To avoid damage to the cooktop, do not cook foods directly
■
on the cooktop.
Cooktop On Indicator Light
The Cooktop On indicator light is located on the control panel.
When any cooktop element on the console panel is turned on,
the Cooktop On indicator light will glow.
Hot Surface Indicator Light
On ceramic glass models, the Hot Surface indicator light is located
on the display panel.
The Hot Surface indicator light will glow as long as any surface
cooking area is too hot to touch, even after the surface cooking
area is turned off.
B
A
C
A. Surface cooking area
B. Cookware/canner
C. / " (1.3 cm) maximum overhang
1
2
/ " (1.3 cm)
1
2
5