EdilKamin SOLEIL plus Installation, Usage Et Maintenance page 36

sk tecnica Multilingua SOLEIL TANIA POLARIS PLUS cod 651370 vers C 03 05 2011.qxp
TANIA plus
33
76
55
60
53
55
60
53
DETAIL. Z
62
screw
COVERING INSTALLATION
screws
screws
screws
55
76
26
19
20
24
62
62
4
55
60
54
62
DETAIL. X
62
2 screws
bushings
24
INCLUDED HARDWARE:
2 M6x25 screws
FIG. A
2 M6x12 screws
4 silicone spacers for ceramic top
8 flat washers diam. 6
2 bushings
The stove comes furnished with its lateral metal side
panels already assembled, while its ceramic upper and
lower front panels (62) and top (26) must be assembled
as follows:
ASSEMBLING THE UPPER FRONT PANEL
Position the ceramic upper front panel (62) against the
metallic front panel support (24) located above the door.
Use an Allen key to fasten the front panel in place using
the 2 supplied M6x25 screws and the 2 supplied M6
washers (the door must be opened before performing this
operation).
60
NOTE:
54
In order to correctly install the upper front panel (62), the
supplied bushing must be positioned between it and the
metallic front panel (24), as indicated in detail "Z".
ASSEMBLING THE LOWER FRONT PANEL
Use the supplied Allen key to loosen the screws that hold
the cast iron lower front grill (4) in place and remove it.
Position the front panel (62) and use an Allen key to
fasten it in place using the 2 supplied M6x25 screws and
the 2 supplied M6 washers, as indicated in detail "X".
ASSEMBLING THE CERAMIC TOP (26).
• insert the 4 ceramics spacers into the 4 free respective
holes in the cast iron top
• position the ceramic top (26) to make sure it rests pro-
perly.
• if necessary, insert a washer between the silicone spacer
and the cast iron top.
NOTE:
If the metal side panels need to be removed, do the fol-
lowing:
Remove the ceramic top (26) and disassemble the rear
panel (33 - by unscrewing the 3 screws indicated in figu-
re A), the two profiles (76), the cast iron top (19) and the
ceramic top (26).
At this point it is also possible to extract the metal side
panels (60) and the two aluminium profiles (55), which
are fitted into the pins of the base.
36
03/05/2011 15.21 Pagina 37