Safety; Important Safety Instructions; Equipment And Usage Safety Requirements - Thermador An American Icon SGS Série Instructions D'installation

Safety

IMPORTANT SAFETY INSTRUCTIONS

READ AND SAVE THESE INSTRUCTIONS
Important Safety
Instructions
Safety Codes and Specifications
Equipment and Usage Safety
Requirements
Power Requirements and Electrical
Grounding Instructions
Gas Requirements
INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE APPLIANCE AFTER
INSTALLATION IS COMPLETE.
IMPORTANT: SAVE FOR THE LOCAL INSPECTOR'S USE.
WARNING:
maintenance can cause injury or property damage. Refer to this man-
ual. For assistance or additional information consult a qualified
installer, service agency, manufacturer or the gas supplier.
• Have the installer show you the location of the circuit breaker or fuse. Mark it
for easy reference.
• Be sure your appliance is properly installed and grounded by a qualified tech-
nician.
• Installation must conform with local codes or, in the absence of local codes
with the National Fuel Gas Code, ANSI Z223.1.
• The appliance must be electrically grounded in accordance with local codes
or, in the absence of local codes, with the National Electrical Code ANSI/
NFPA 70, latest edition. (In Canada, installation must be in accordance with
the CAN 1-B149.1 and .2 Installation Codes for Gas Burning Appliances and/
or local codes.)
• This appliance has been tested in accordance with ANS Z21.1, Standard for
Household Cooking Appliances (USA) and in accordance with CANl.l-M81
Interim Reqt #58 Domestic Gas Cooktops (CANADA).
• Additional requirements and standards may apply in specific installations.
• The cooktop must be used in conjunction with a suitable ventilation system.
• This appliance is equipped with an intermittent/interrupted ignition device.
(Models SGSX304, SGSX365 and SGSX456 only)
• Before you plug in an electrical cord, be sure all controls are in the OFF posi-
tion.
• Power Supply: 120 Volts, 15 Ampere, 60 Hz. This appliance is factory
equipped with a 5-foot power supply cord with a 3-prong grounding plug (with
polarized parallel blades).
• To prevent electrical shock, the third ground prong should not under any cir-
cumstances, be cut or removed. It must be plugged into a matching grounding
type receptacle, connected to a correctly polarized 120-volt circuit.
• A separate circuit is recommended which is in compliance with the NEC. If
there is any doubt as to whether the wall receptacle is properly grounded, the
customer should have it checked by a qualified electrician.
• A manual valve must be installed in an accessible location in the gas line
external to the appliance for the purpose of turning on and shutting off the gas
to the appliance.
Improper installation, adjustment, alteration, service or
English 1