Petporte Smart Fl Ap Installation Into Walls; Assembly Instructions - Petsafe Staywell Petporte smart fl ap Manuel D'utilisation

Petporte smart fl ap
Wall fi xing screws are not provided with this catfl ap as the type needed will vary greatly depending on the wall construction. Various fi xing types are
available from hardware and D.I.Y. stores depending on the wall construction: chemifi x bolts and nuts, screws fi xed into inter-set or plastic rawl plugs,
nylon self drill or polytoggle.
1. An opening must be formed in the wall at the appropriate height and size for your cat to be scanned, based on the Cutting Template provided. The
opening should be formed by a qualifi ed builder avoiding utility supplies and not damaging the integrity of buildings damp-proof courses.
The principle difference between fi tting the Petporte smart fl ap
to the wall.
2. To fi x the interior section to the wall utilise the four, 5 mm diameter holes in the corners of the interior section that are accessible with the large
interior cover plate removed.
3. To fi x the exterior section to the wall utilise the two, 6 mm diameter holes in the sides of the exterior section that support the porch.
The Petporte smart fl ap ® comes with a single Extension Tunnel that provides 52 mm length. Extra Extension Tunnels can be purchased, with each
individual tunnel providing 40 mm additional length. These are not provided with the Petporte smart fl ap
consumers prefer to form their own tunnels by using marine grade plywood or other materials.
Please refer to the Accessories section of this guide for information on purchasing additional Extension Tunnels.
We do not accept responsibility for incorrect operation of the unit should modifi cations be made to the antenna coil.
Under no circumstances should you alter or adjust the windings of the antenna coil.
_______________________________________________________________________________________

Assembly Instructions

Fig. 1
Pass the porch cable from the
porch through the small rectangular
opening in the exterior section.
10
® Installation into Walls
® through a wall and a door is the method of fi xing the interior and exterior sections
® because wall thicknesses vary. Some
Fig. 2
Pass the four "mushrooms" pins
through the back of the exterior
section into the porch.