Before Switching On The Power Supply; Safety Instructions - Kenwood M-819DAB Manuel D'utilisation

Before switching on the power supply

IMPORTANT SAFETY INSTRUCTIONS
Attention: Please read through this sheet carefully in order to ensure safe operation of the device.
Read notes carefully!
- Please comply with all safety and operation instructions when you put this product into operation.
Keep these instructions in a safe place!
– Please keep the safety and operating instructions for later reference.
Please comply with all warnings!
– Please comply rigorously with all warnings given on the product and cited in the operating manual.
1. Clean with a dry cloth only!
– Remove the mains plug of this device from the mains socket before you clean the product. Never
use fluid cleaning solution or cleaning spray. Use only a damp cloth for cleaning.
2. Accessories
– Only use the accessories specified by the manufacturer.
3. Do not use this device near water
– The device should never be exposed to water drops or water spray - as for instance would be occur
near a bath, bathroom sink, kitchen sink, washing machine in a damp cellar or near a swimming pool
etc. Never place containers filled with liquid such as, for instance, a vase of flowers, on the device.
4. Ventilation
– The slits and openings in the housing serve to ventilate the device to ensure the reliable operation
of the device and to protect the device from overheating and potential spontaneous combustion.
Please do not block the ventilation openings. Please install the device according to the manufacturer's
instructions. Never block the ventilation openings by placing the device on a bed, sofa, rug or similarly
soft underlay. This device should not be installed in a bookshelf or built-in cupboard if sufficient venti-
lation has been ensured as described in the manufacturer's installation instructions.
5. Power supply
– This device may only be connected to the mains power supply which is specified on the device. If
you are unsure which type of power supply is in your home, please contact your specialist supplier or
the local energy supply company.
6. Mains cable
– Make sure that the mains cable is not in a position where someone can trip over it nor that it can
be disconnected in the immediate vicinity of a socket including additional sockets. Also it should not
be crushed in any way when coming out of the device.
7. Thunderstorms
– Disconnect from the mains supply in the event of thunderstorms or if not used for a longer period.
8. Overload
– Never overload the mains sockets, extension cables or power strips because otherwise there is a risk
of fire or electrical shock.
9. Entry of foreign material or liquid
– Take care that foreign material or liquid never enter into the device through the ventilation open-
ings, since otherwise contact with high voltage components or short circuit with a resulting fire or
electric shock can occur. Never spill liquid of any kind on this device.
3