Symbols Used - Josef Ganter Feinmechanik 1000204 Mode D'emploi

FB-EV 064 GA Ratsche Rev. 2 (Version: 25.11.2020) | (Translation: 25.11.2020)
Mechanically or visibly damaged, corroded or contaminated implements should not be used. Repreparation can be negatively affected due
to surface defects of the implements. Josef Ganter GmbH is not liable for any damage or injury caused by misuse.
The same applies for any damage caused by improper repreparation or handling such as disproportionate mechanical impacts, falling down,
mech. overload, etc.
9 Repairs / maintenance
Josef Ganter GmbH offers a repair and inspection service for the ratchets. We recommend sending in the implement for inspection at least
once a year. If the implements are repaired by companies or persons which are not expressly authorised to do so by Josef Ganter GmbH,
all guarantees shall become null and void.
The implement must be visibly cleaned and sterilised according to these guidelines before being dispatched (e.g. by using a cover indicator
on sealed sterilised foil). Otherwise, the product will be returned by Josef Ganter GmbH to the sender at their expense and without further
processing.
10 Disposal
If the implements can no longer be repaired or prepared, they should be disposed of according to the general waste management
of practice or clinic waste. Regional regulations must be observed for the disposal.
11 Additional information
Additional jointly applicable requirements for the preparation of medical products can be found under www.rki.de or www.a-k-i.org
12 Information about the symbols used and the manufacturer

Symbols used

Description / Symbol for ...
Symbol
... Manufacturer
... Article number
... Serial number - Batch
... Observe user instructions
... CE compliance
... Medical device
... Non-sterile
... Warning
User instructions
Ratchets
Page 5 of 5
Josef Ganter Feinmechanik GmbH
Niedereschacher Str. 24
DE-78083 Dauchingen
 +49 (07720) 60995-0
info@josefganter.de
www.josefganter.de