AKG D 542 Mode D'emploi page 12

2 Installation and Connection
2.2.1 Desktop
Installation
Refer to fig. 4 for
connector pinout.
Fig. 5: Using the
optional PS 3 F-
Lock to install the
microphone.
3 Use
4 Cleaning
12
19 mm max.
place using the screws supplied with the
PS 3 F-Lock.
4. Connect the microphone to the XLR connector
on the PS 3 F-Lock.
5. Tighten the securing screw (2).
To mask unwanted ambient noise and obtain
optimum intelligibility, we recommend talking into
the front grill of the microphone from a distance of
about 4 inches (10 cm).
Clean the surface of the microphone body with
(methylated) spirits or alcohol.
1. Drill a
(17-mm) hole in the
desktop.
2. Unscrew the shell
(1) and solder a two-
conductor shielded
cable to the XLR
connector. Replace
the shell (1).
3. Thread the cable
through the installa-
tion hole and fix the
PS 3 F-Lock in
11/16"