Silverline 30-135A Mode D'emploi page 11

380736
Storage
• Store this tool carefully in a secure, dry place out of the reach of children. If the tool has a
permanent mains connection prevent access by children to the workshop or garage.
Disposal
Always adhere to national regulations when disposing of power tools that are no longer functional
and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE), with
household waste
• Contact your local waste disposal authority for information on the correct way to dispose of
power tools
Troubleshooting
Problem
Lower Roller (18) and Upper Roller
(21) do not turn
Lower Roller (18) and Upper Roller
(21) turn but wire does not feed
The welder stops working
during use
Poor weld
MIG/MAG Combination Gas/No Gas Welder
Possible cause
No power
Wire Feed Speed Dial (6) set to minimum 0 setting
Incorrect roller pressure
Torch Cable (14) liner damaged
Wire welded to Tip (10)
Duty cycle exceeded and Over-Heat Indicator (5) is
illuminated
Incorrect current and feed settings
Solution
Switch on welder
Increase setting
Adjust Roller Tension Adjuster (19)
Check and replace liner
Release wire from Tip
Leave the welder for 20-30 minutes to cool down
Adjust Voltage/Current Selector (7) and Wire Feed Speed Dial (6)
silverlinetools.com
11