Makita CL105D Manuel D'instructions page 10

Clean out also the suction opening, dust
bag/dust pack mounting area and the dust
stopper.
CAUTION:
Never use gasoline, benzine, thinner,
•
alcohol or
deformation or cracks may result.
008934
Wash the dust bag in soapy water when it
is clogged with dust and the cleaner power
becomes small. Dry it out thoroughly before
use. An insufficiently dried bag may cause
poor suction and shorten the service life of
the motor.
NOTE:
Dust pack is a throw-away type.
•
When the sponge filter is clogged with dust,
remove it from the cleaner and then wipe it
off or wash in water.
Removing and installing the sponge
filter
1
014741
To remove the sponge filter, remove the
dust bag or dust pack and then pinch and
take it out.
the like. Discoloration,
1. Sponge filter
1
014742
Press in the whole edge of the sponge filter
against the recessed wall inside the dust
bag/dust pack mounting area.
CAUTION:
After cleaning sponge filter, be sure to
•
install it on the cleaner. If washed in
water, dry it up before installing. An
insufficiently dried sponge filter may
shorten the service life of the motor.
10
1. Sponge
2. Recessed wall
2