Pleasant Hearth OFG418TA Mode D'emploi page 15

ASSEMBLY INSTRUCTIONS
9. Burner Assembly Installation
9-1. Line up holes in the burner assembly (B) with
corresponding holes in the table assembly.
Insert four M5X12 screws (EE) through holes.
Fasten them. The control knob should face the
front side of the unit, the same as the door.
Hardware Used
EE
Screw M5 X 12
FF
Phillips screwdriver
9-2. The assembled unit will look like the figure 9-2.
10-1. Screw the knob (O) on the table lid (A) with
M4 X 5 screw (AA). Pour glass rocks (one
pack) (P) above the burner and put the table
lid above the burner assembly. Do not cover
ignition screen with glass rocks.
Caution: Never place a table lid on the
fire pit when in use. Ensure the fire pit
has cooled before placing a table lid over
the fire pit.
Hardware Used
AA
Screw M4 X 5
FF
Phillips screwdriver
9-1
X 4
X 1
9-2
10-1
P
X 1
X 1
15
EE
0
B
A