Pleasant Hearth OFG418TA Mode D'emploi page 14

ASSEMBLY INSTRUCTIONS
7-2. After assembly, the base assembly will look like
figure 7-2.
8. Table Installation
8-1. Lay assembled table upside down on floor. Line
up holes in assembled table with corresponding
holes in base assembly. Insert eight M6 X 12
bolts (DD) through holes. Tighten them.
Hardware Used
DD
Bolt M6 X 12
FF
Phillips screwdriver
8-2. After assembly, the unit will look like figure 8-2.
7-2
8-1
X 8
X 1
8-2
14
Base assembly
Base assembly
Base assembly
DD
TT
TT
TT