Checklist; Location Requirements - Dacor DOC30M977D Instructions D'installation

Installation requirements

Checklist

Review these items to verify proper installation:
1. Before installation, read this manual thoroughly to familiarize yourself with the
installation process.
2. Verify the cabinet dimensions are correct and the required electrical connections
are present.
3. To lift the oven, hang the install handles on the oven's sides.
4. Move the oven into place in front of the cabinet cutout, leaving the bottom
packaging on the oven to avoid floor damage.
5. Detach the oven from the pallet, and carefully team-lift the oven into the cutout.
6. Ensure the electrical conduit reaches to the connection point properly.
7. Slide the unit fully into place, while routing the electrical conduit correctly.
8. With a Phillips screwdriver and supplied screws, anchor the oven to the cabinetry.
9. Ensure that all installation procedures are followed as instructed.
10. All product literature and accessories are included with the oven.

Location requirements

IMPORTANT: Observe all governing ordinances.
• Specified cabinet-opening dimensions are minimums and must be followed.
• Cabinet recess must enclose all but the oven face.
• Grounded electrical supply is required. (See Electrical connection.)
• Locate the junction box no more than 3" (7.6 cm) below the support platform. Drill
a minimum 1" (2.5 cm) diameter hole in the right- or left-rear corner of the
platform for easy power-plug access to the junction box.
• The support platform must be solid, level, flush with base of the cabinet cutout,
and able to support 287 lb (130 kg).
• Install the oven at least 12" (30 cm) from other appliances.
IMPORTANT: Consult your builder or cabinet supplier to ensure the materials used will
not discolor, delaminate, or be otherwise damaged. This oven complies with UL and CSA
International requirements and with the maximum allowable wood-cabinet temperature
of 194 °F (90 °C).
7
English