Control Panel - Transcend 3 minicpap Guide Rapide

Transcend 3 miniCPAP Quick Guide
4. Insert the barrel connector of power supply into power jack on the back of the
Transcend 3 miniCPAP device.
5. Insert the other end of the power supply into an AC line power outlet.
6. The Transcend 3 miniCPAP power-up LED flash sequence should initiate. Once
the power-up LED flash sequence is complete the LED lights will turn off. This
sequence indicates that power is being supplied to the Transcend 3 miniCPAP
and that it has successfully entered Standby Mode.
Note: Use only the Somnetics-supplied Universal Power Supplies. Do not use a
power converter or voltage transformer with the PSA2 Universal Power Supply.
Note:
Make certain that the plug attachment is fully secured to the Power Supply
before inserting the power supply into the wall outlet.
Transcend 3 miniCPAP Device
The Transcend 3 miniCPAP comes ready to generate and regulate continuous positive
airway pressure therapy for delivery to the interface (mask). An external power source
connects to the Transcend 3 miniCPAP to supply power to the device.

Control Panel

The Transcend 3 miniCPAP control panel has two pushbuttons used to activate the blower
and the pressure ramp feature. There are also two LED lights, including a green LED for
indicating normal operational modes and a yellow LED that indicates fault conditions.
Remove:
Remove
Depress button
Plug
and turn
Reattach: Insert
plug and turn
Page 7