Accessories (Sold Separately) - Transcend 3 minicpap Guide Rapide

Transcend 3 miniCPAP Quick Guide

Accessories (Sold Separately)

Transcend Mobile Power Adapter

Transcend P

Transcend P

Transcend Portable Solar Battery Charger (to be used as an alternative charging

source for Transcend P
Bluetooth Module

 Patient Mask
Assembling the Transcend 3 miniCPAP Device
1. Attach the air supply tube to the air outlet on the Transcend 3 miniCPAP device.
2. Connect the mask to the opposite end of the air supply tube.
3. Plug the power supply barrel connector into the Transcend 3 miniCPAP power jack
on the rear of the device.
4. Connect power supply to a wall outlet.
Using the Multi-Plug Universal Power Supply
(PSA2)
The Multi-plug Universal Power Supply (PSA2) and Changeable Plug Pack containing three
(3) exchangeable plugs are contained with each Transcend 3 miniCPAP. The changeable
plug packs are suitable for use in most countries around the world.
1. Determine which plug is required to power the device based upon the outlet
style.
2. If the correct plug is not already attached to the Power Supply remove the
attached plug by depressing the button on the detachable plug and turning the
plug in a counterclockwise motion until it releases from the power supply.
3. Attach the desired plug by lining up the protruding tabs on the back of the plug
with the gaps on the Power Supply and gently pushing the plug into the slot.
Turn the plug clockwise until it clicks into place. You should hear an audible
click.
Battery
4
Battery
8
and P
4 8
batteries)
Page 6