Cleaning The Exterior - Transcend 3 minicpap Guide Rapide

Transcend 3 miniCPAP Quick Guide
Caring for your Transcend 3 miniCPAP and its
Components
Warning:
Unplug the Transcend 3 miniCPAP before cleaning.

Do not submerge the Transcend 3 miniCPAP or power supply in liquid.

Prevent water from entering any openings of the device.

Do not use harsh or abrasive cleaning agents to clean the device or any

components.
Remove the filter assembly by pulling the tab on the back of the device to release it. Then
pull the filter assembly away from the device. Discard the entire filter assembly and
replace with a new one.
Do not attempt to sterilize the Transcend 3 miniCPAP.
Do not place cleaning materials, such as a cloth or liquid, into the device air inlet or air
outlet connector.

Cleaning the Exterior

Follow these instructions to clean the exterior of the Transcend 3 miniCPAP.
1. Unplug the power supply prior to cleaning and disconnect the device from power
cords.
2. Mix a solution of 5% mild liquid detergent in distilled water (1.6 fl oz liquid
detergent per quart of distilled water). Mild detergent should contain biodegradable
anionic surfactants and no phosphate.
3. Submerge a lint-free cotton cloth into the detergent solution.
4. Wring excess water from the cloth then wipe the exterior of the Transcend 3
miniCPAP device for approximately 20 seconds using a gentle, back and forth
wiping motion from the front to back of the device. Apply firm pressure and ensure
contact with all accessible contact surfaces to adequately remove soil buildup.
5. Rinse the cloth in clear water to remove residual cleaning solution.
6. Wring excess water from the cloth then wipe the Transcend 3 miniCPAP using a
gentle front to back wiping motion to remove any detergent solution remaining on
its surface.
7. Wipe the device with a dry, lint-free cotton cloth until the device is fully dry.
Page 14