Renishaw OMM Guide D'installation Et D'utilisation page 17

FITTING FLEXIBLE CONDUIT
Recommended flexible conduit is Thomas and Betts
SHURESEAL 1/4in Part No. TBEF 0250-50 or
equivalent. Use the plastic olive when fitting
flexible conduit.
When tightening nut C onto the conduit, first
tighten until finger tight, then tighten an additional
1.5 to 2.5 turns. This will achieve a seal to BS 5490
(IEC 529) to IP67, between the flexible conduit and
the conduit adaptor.
FITTING RIGID CONDUIT (Bundy Tube - Ø12 mm hydraulic pipe)
An alternative brass olive is supplied, to enable rigid conduit
to be fitted.
1. Remove nut C, the flexible conduit termination piece and
plastic olive by sliding to the end of the cable.
2. Discard the plastic olive and conduit termination piece.
3. Fit the brass olive over the cable, followed by nut C.
4. Pass the OMM cable through the rigid conduit and
engage the conduit in the conduit adaptor.
5. Tighten nut C to 25 - 27 Nm (18.55 - 19.91 lbf.ft),
ensuring that the torque is resisted on the flats
of nut B.This will achieve a seal to BS 5490
(IEC 529) to IP67, between the rigid conduit
and the conduit adaptor.
Cable
Flexible
conduit
Nut - B
Brass
olive
Nut - C
1-7
Nut - B
Conduit
termination
piece
Plastic
olive
Nut - C
Adaptor
thread
Cable
Rigid
conduit