Fitting Label And Window - Renishaw OMM Guide D'installation Et D'utilisation

FITTING THE LABEL
1. Replace the label and turn the screws 1/4
of a turn clockwise, to hold the label in place.
FITTING THE WINDOW
1. Before fitting window, check for any damage
to screws or scratch marks
sealing.
2. Ensure that the 'O' ring seating in the OMM body is
clean, and there are no scratch marks which could
prevent complete sealing.
3. Ensure that the window and 'O' ring are clean.

FITTING LABEL AND WINDOW

which could prevent
4. Insert the two short screws into window holes A,
and tighten.
Screw torque is 0,3 - 0,7 Nm. (0.22 - 0.51 lbf.ft).
5. Place window complete with 'O' ring onto OMM
body.
Note : The 'O' ring should be lubricated with
silicon grease to prevent nicking.
6. Insert the long screws into holes B. Tighten each
screw a few turns at a time, to pull the window
down evenly.
There may be some resistance due to compression
of air trapped inside the body.
Screw torque is 1,0 - 1,8 Nm. (0.74 - 1.32 lbf.ft).
A
B
B
A
1-3