Zolia Premium Mode D'emploi page 3

Main Features
● The digital display shows the levels of vibration, shock, sensitivity.
● Increase the sensitivity, vibration, and shock levels by tapping the corresponding button.
● H/M/L Sensitivity levels: L(low) is for the least sensitive, and H(high) is for the most sensitive.
● 0 /L/M/H Vibration levels: 0 is off, L(low) is subtle vibration, and H(high) is heavy vibration.
● 0 /L/M/H Shock levels: 0 is off, L(low)is mild static shock, and H(high)is strong no harm static shock.
● The collar is lightweight by design to place the least amount of stress on your dog.
● The collar size can be adjusted between approximately 6.5'' to 24'' in circumference.
● The collar is reflective for nighttime visibility.
● The receiver is rainproof and safe for outdoor use
Precautions
Before using it for the first time the product should be fully charged.
Charge the collar
Plug the USB cable into the bottom of the receiver as shown in the image above. The bark collar can charge in
less than 2 hour and can hold a charge for up to 14 days. When charging the product, the digital display will show
the power level and continue to flash. When the product is fully charged, the digital display will show 7 and off.
ON-OFF
Tap the Power Button once to turn it on which is signaled by 1 beep, and hold the Power Button for 3 seconds
again to turn it off which is signaled by 2 short beeps. Once on, tap the Power Button once to see how much
charge is left (L low to H full).
Changing the Vibrate, Shock, and Sensitivity Levels
While the bark collar is on, tap any of the Vibrate, Shock, or Sensitivity levels to see the current level. While the
current level is displayed (stays lit for 3 seconds), tap the button again to change the corresponding level.
Product Working Principle
This product uses a combination of both sound and vibration to automatically detect your dog barking with
precision, and eliminates false triggering from other dogs. It will use any combination of Beep, Beep + Vibrate,
Beep + Shock, or Beep + Vibrate + Shock to correct and train your dog to stop barking.
Auto-Protection Mode
The bark collar will go into Sleep Mode for 1 minute if your dog barks more than 7 times in 1 minute. The display
will flash E(Error) a minute when in Sleep mode which can be cancelled by pressing any button. The bark collar
will return to active mode after being in Sleep for 1 minute.
Tips
● At first use Beep mode only and adjust only Sensitivity and Collar Size to ensure the best fit for your
dog's size and temperament before raising Vibrate and Shock levels.
● Sensitivity 7 is designed to be extra sensitive and can trigger the collar by irregular actions that place
excessive force on the sensor like rubbing against the sensor directly, a hard drop, or a large dog
shaking it around their neck.
3