Maintenance & Care; Centering The Running Belt - Sunny Health & Fitness SF-T7718 Instructions D'utilisation

General cleaning will help prolong the life and performance of your treadmill. Keep the unit clean and
maintained by dusting the components on a regular basis. Clean both sides of the Running Belt (No.
C31) to prevent dust from accumulating underneath the Running Belt (No. C31). Keep your running
shoes clean so that dirt from your shoes do not wear out the Running Board (No. D18) and Running
Belt (No. C31). Clean the surface of the Running Belt (No. C31) with a clean damp cloth.
To better maintain and prolong the life of the treadmill, it is recommended that the treadmill be
powered off for 10 minutes every 2 hours and fully powered off whenever not in use.
A loose Running Belt (No. C31) will result in the runner sliding off when running, while too tight of a
Running Belt (No. C31) will negatively affect the motor's performance and create more friction
between the roller and Running Belt (No. C31). The most suitable tightness for the Running Belt
(No. C31) is pulled out 50-75mm from the Running Board (No. D18).

CENTERING THE RUNNING BELT:

Place the treadmill on level ground and set it at 3-5mph to check if the Running Belt (No. C31) drifts.
If the Running Belt (No. C31) moves
to the right, turn the adjusting bolt on the
right side ¼ turn clockwise, then turn the
left adjustment
counter-clockwise. If the Running Belt
(No. C31) does not move, repeat this
step until it centers. Refer to Figure A.
If the Running Belt (No. C31) moves
to the left, turn the adjusting bolts on the
left side ¼ turn clockwise, then turn the
right adjustment
counter-clockwise. If the Running Belt
(No. C31) does not move, repeat this
step until it centers. Refer to Figure B.
Over time the Running Belt (No. C31)
will loosen. To tighten the Running
Belt (No. C31) turn the Left & Right
side adjustment bolts one full turn
clockwise, check the tension of the
Running Belt (No. C31). Continue this
process until Running Belt (No. C31)
is at the correct tension. Make sure to
adjust both sides equally to ensure
correct belt alignment. Refer to Figure
C.
MAINTENANCE & CARE
bolt ¼ turn
bolt ¼ turn
18