Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
10
12 Volt Trigger Input
0
The RDD-1580 can be activated by a 12 volt trigger signal. The trigger
input accepts any control signal (AC or DC) ranging from 3 volts to 30 volts.
When a cable is connected to the 12V input and a trigger signal is present,
the RDD-1580 is activated. When the trigger signal is turned off, the unit goes
into standby mode. The front panel standby indicator remains illuminated,
but the unit will not operate.
Audio Controls
Source Input
4
B
The Source Input selects the input signal source. From the front panel or
remote press the corresponding input key to select the source to listen to.
Repeat F
Some audio source devices support the use of the repeat function including
Repeat Track, Repeat Album, Repeat Off. Press the Repeat key
remote control to toggle these functions. The USB source LED
as follows to indicate the currently activated Repeat function.
Repeat Off: One time blink [Factory Default]
Repeat Album: Two times blink
Repeat Track: Four times blink
Random E
Some audio source devices support Random playback of music. Press the
Random key
on the IR remote control to toggle the Random function.
E
The USB audio source LED will blink as follows to indicated the currently
activated function
Random Off: One time blink [Factory Default]
Random On: Two times blink
Factory Default
The RDD-1580 can be reset to restore the factory Default settings. To restore
factory defaults press and hold the front USB source input key
5 seconds until all Source LEDs are blinking. Release the USB source input
key and the RDD-1580 will restore factory settings and restart.
Troubleshooting
Most difficulties in audio systems are the result of incorrect connections, or
improper control settings. If you encounter problems, isolate the area of the
difficulty, check the control settings, determine the cause of the fault and
make the necessary changes. If you are unable to get sound from the unit,
refer to the suggestions for the following conditions:
Standby Indicator Is Not Illuminated
No main power to the unit. Check AC power connections at the unit and
the AC outlet.
Fuse Replacement
If another electrical device works when plugged into the power outlet,
but the Standby Indicator of the unit does not light when plugged into the
same outlet, it indicates that the internal power fuse may have blown. If
you believe this has happened, contact your authorized Rotel dealer to get
the fuse replaced.
F
on the IR
No Sound
4
will blink
If the unit is getting power, but is producing no sound, check the INPUT
INDICATORS on the front panel. Make sure the selected source is connected.
Also check to make sure the analog outputs of the unit are properly connected.
Can not play 24 bit 192kHz source
96kHz and 192kHz playbacks are only available through the rear digital
inputs. Please also note that many media players are not capable of decoding
24bit 192kHz audio files. Please make sure your player can decode 24bit
192kHz files. Also, confirm the RDD-1580 PC-USB input is configured to
USB 2.0 Audio and the Windows audio driver is installed on your computer.
(See PC-USB Input in the manual for more details)
NOTE: MAC computers do not need a driver but require software that
supports 24bit 192kHz playback but still require the RDD-1580 PC-USB
input to be conferred to USB 2.0 Audio.
Cannot Connect via Bluetooth
4
for
If you cannot pair your Bluetooth enabled device to the RDD-1580, delete
the memory of the previous connection on the RDD-1580 and on your
device. On your device this is often listed as "Forget this Device". On the
RDD-1580 IR remote PRESS and HOLD the PAUSE
until the USB indicator flashes rapidly then release the button. Then try to
make the connection again.
RDD-1580 Digital to Analog Converter
C
button for 5 seconds
Publicité
Chapitres
Table des Matières
