Kimex 048-1 W Série Manuel De Montage page 29

Movement Order
ID
Entrer
Sortir
Stop
4. Operation
If the power is off for more than 10 seconds and
is then switched on again, 1 x beep is emitted. Within 10 seconds, the host sends
an ID command through 485 to the controller. After receiving the command, the
controller registers the ID in the controller, checks the response signal back to
the host, and beeps 5 times. The operation is now complete.
Exemple
0X02 485-A:55 00 00 00 00 02 05 ID0 ID1 ID2 ID3 crcH crcL
485-B:AA ID0 ID1 ID2 ID3 02 01 crcH crcL
0x04 485-A:55 ID0 ID1 ID2 ID3 04 02 crcH crcL
485-B:AA ID0 ID1 ID2 ID3 04 01 crcH crcL
0x05 485-A:55 ID0 ID1 ID2 ID3 05 02 crcH crcL
485-B:AA ID0 ID1 ID2 ID3 05 01 crcH crcL
0x06 485-A:55 ID0 ID1 ID2 ID3 06 01 crcH crcL
485-B:AA ID0 ID1 ID2 ID3 06 01 crcH crcL
13