Locking The Screen - Kimex 048-1 W Série Manuel De Montage

Screen mounting
6. Finally, attach the protective covers to the sides of the screen housing.
To remove them, pull them out of the housing and down at the same time
(picture 6).
Picture 6
Editing is now complete.
Screen management
Operating the display with the wall swith
Connect the cable to an electrical outlet. (Check the voltage) Install the cable so
that it does not become an obstacle, is not twisted and is not near heat sources! If
you need an extension cable, please use it.
Unrolling the screen (Fig. 2)
Set the switch to the < = > position, the screen will unroll itself and stop
automatically when it has reached its maximum height. We inform you of the
drop of the canvas between 80 and 120 cm from the ground.
Rolling up the screen (Fig. 3)
Set the switch to the < upper > position, the screen rolls up by itself and stops
automatically when it is fully rolled up.

Locking the screen

When the screen reaches the desired size, set the switch to the < stop > position,
the screen will stop.
8