Kimex 048-1 W Série Manuel De Montage page 27

Remote control decoding/encoding
Canvas tension adjustment
With your canvas rolled up, please just connect
the power cable to the screen crancase but not
yet to the electrical outlet.
1 / Press the UP button on your remote control for
3 seconds until the top LED flashes three times,
keep your finger on the button.
2 / Connect the power supply to your screen.
3 / Release the UP button on the remote control.
4 / Press the UP button again and once down on
your remote control, your canvas will then
descend on its own, the frequency of your remote
control is set.
1 / Press the UP button on your remote control for
3 seconds until the top LED flashes three times,
keep your finger on the button.
2 / Connect the power supply to your screen.
3 / Press the DOWN button on your remote
control for 3 seconds until the bottom LED flashes
three times, keep your finger on the button.
4 / Press the DOWN button on your remote
control again, the frequency of your remote
control is deprogrammed.
To adjust the tension of the screen fabric, use
the wheels located on the 2 ends of the weight
bar and turn in either direction to loosen
or tighten the canvas as needed.
Use the
wheel
11