Deleting A Scene; Deleting A Bank Of Scenes; Deleting All Scenes - Chauvet DJ Obey 40 Mode D'emploi

Deleting A Scene

Deleting a Bank of
Scenes
Deleting All
Scenes
Page 24 of 160
Deleting a scene is removing a look from a scene button so it cannot be played back in Playback
mode.
Deleting a scene that has been saved as a step in a chase will also delete the step in the
chase.
The general instructions for deleting a scene are as follows:
1. Enter Program mode.
2. Use bank buttons to go to the bank where the scene to be deleted is stored. The LCD display
shows the current bank just above the word Bank.
3. Delete the scene by pressing <Auto/Del> and then the scene button.
4. Repeat steps 2–3 as needed for other scenes.
5. Exit Program mode.
6. Reset faders to 0 and deactivate blackout.
Note: A scene can be deleted in Program mode when it is active in Playback mode.
The specific instructions below describe deleting <SCENES 4> of bank 2.
1. Enter Program mode.
2. Press <Bank Up> or <Bank Down> until 2 shows on the LCD display just above the word Bank.
3. Press and hold <Auto/Del> and then press <SCENES 4>. The LCD display and fixture LEDs
flash to indicate a successful operation.
4. Repeated steps 2–4 as needed for other scenes.
5. Exit Program mode.
6. Reset all the channel faders to 0.
Press <Blackout>to deactivate blackout and allow DMX transmission from the board.
Deleting a bank of scenes is deleting all 8 scenes in a bank so they cannot be played back in
Playback mode. The general instructions for deleting a bank of scenes are as follows:
1. Enter Program mode.
2. Use bank buttons to go to the bank to be deleted. The LCD display shows the current bank just
above the word Bank.
3. Press and hold <Auto/Del> and <Music/Bank Copy> together. The LCD display and fixture
button LEDs flash to indicate a successful operation.
4. Repeat steps 2–3 as needed for other banks.
5. Exit Program mode.
6. Reset faders to 0 and deactivate blackout.
The specific instructions below describe deleting bank 30.
1. Enter Program mode.
2. Press <Bank Up> or <Bank Down> until 30 shows in the LCD display just above the word
Bank.
3. Press and hold <Auto/Del> and <Music/Bank Copy> together. The LCD display and fixture
button LEDs flash to indicate a successful operation.
4. Repeat steps 2–3 as needed for other banks.
5. Exit Program mode.
6. Reset all the channel faders to 0.
7. Press <Blackout>to deactivate blackout and allow DMX transmission from the board.
Deleting all scenes is removing all the scenes that have been saved in any one of the banks.
To delete all the scenes in the board, but not delete the fader customizations, do the following:
1. Turn the board off.
2. Press and hold <Bank Down> and <Program>.
3. Continue holding <Bank Down> and <Program> and turn the board on.
4. Continue holding <Bank Down> and <Program> until the LCD display and fixture button LEDs
flash.
5. Release <Bank Down> and <Program>.
Obey 40 User Manual Rev. 9