Pan Detector - Kuppersbusch KI6350.0SR Manuel D'utilisation Et D'entretien

EN
Figure 3
If you do not take any action in the
next 10 seconds the touch control will
switch off automatically.
When the touch control is activated,
you can disconnect it at any time by
touching the touch button
if it has been locked ("Childproof lock"
function activated). The touch button
(1) always has priority to disconnect
the touch control.
You can remove the knob
(2) from its housing at any
time. Through this action you
are blocking the rest of sensors.
This action is useful as safety
measure for avoiding non-desired
manipulations by children. When
the knob is placed again in its
position, the sensors will be
available again .
Inside the knob's housing, an
only-off sensor is available (12) that
will allow you to switch off the hob
when the knob is out of its position.
PLATES ACTIVATION
32
Once the Touch Control is activated
through the sensor
can be switched on by following
these steps:
1 You have to choose the desired
zone for cooking by means of
pressing the zone selection sensor
(3). The power indicator (4) will
blink. Twisting the knob rightwards
or leftwards, the power level can
be set between 0 and 9. The
power value will be shown on the
corresponding power indicator (4).
2 By means of knob twist (2) a new
cooking level between 0 and 9 can
be chosen.
As long as the plate is selected, its
(1), even
power level can be modified.
TURNING OFF ONE PLATE
If a zone is already selected, twist
the knob (2) leftwards until level 0 is
reached. The hotplate will switch off.
If switching off a zone, an H appears
on its power indicator (4), it means
the glass surface has reached high
temperature, there is risk of burns.
When the temperature decreases,
the power indicator (4) switches off.
TURNING ALL PLATES OFF
All plates can be simultaneously
disconnected by using the general on/
off sensor
(4) will turn off. If the heating zone
turned off is hot, its power indicator
(4) shows an H.
(1), any plate
(1). All plate indicators

Pan detector

Induction cooking zones have a built-in
pan detector. This way, the plate will
stop working if there is no pan present
or if the pan is not suitable.
The power indicator (4) will show
alternatively the symbols
,to designate ''there is no pan'' if, while
the zone is on, no pan is detected or
the pan is not suitable.
If a pan is taken off the zone while it
is running, the plate will automatically
stop supplying energy and it will
show the symbol for "there is no pan".
When a pan is once again placed
on the cooking zone, energy supply
will resume at the same power level
previously selected.
The time for pan detection is 3 minutes.
If a pan is not placed within this time
period, or the pan is unsuitable, the
cooking zone shuts off.
When finished, turn off the
cooking zone by using the knob.
Otherwise an undesired operation
could occur if a pan is accidentally
placed on the cooking zone during
the three minutes. Avoid possible
accidents!
Childproof Lock Function
With the "Childproof Lock " function,
you can block the other sensors,
except for the on/off sensor
fig.2
and
(1), in